Information for Exhibitors and Stand Builders

Welcome to the bcc!

The following instructions must be observed to ensure the smooth setup and dismantling of your exhibition stand:

Stand construction

  • The stand must be set up within the specified markings.
  • Marked escape and rescue routes must be kept clear at all times.
  • The specified setup and dismantling times must be adhered to.
  • Storing deposit bottles behind the stand is not permitted.

Stand Inspection

After the stand setup has been completed, this must be reported at the main entrance or the Front Office as the stand must be approved by the bcc.

Damage Prevention

  • Do not drill into floors, walls or ceilings, and do not affix anything to walls, windows or doors.
  • Do not saw any materials inside the bcc.
  • Use transport trolleys with rubber or nylon wheels only.
  • The bcc only permits the use of adhesive tape explicitly designated for the respective surfaces. This especially applies to the laying of floor coverings. It is the operator's responsibility to ensure that the adhesive tape suits its intended purpose of use, as this is dependent upon various factors including temperature, strain, materials to be taped and handling. The bcc GmbH assumes no liability.

Contact Person On Site

The Front Office is glad to assist you with all questions concerning your exhibitor booth (+49 30 23806555, exhibitor@bcc-berlin.de), for example,

  • if you have delivered something to the bcc, or
  • if you ordered a screen.

The Front Office is located on the ground floor on level B on the driveway side:

Lageplan Front Office.png